360101 375 LEG PRESS ADAPTER KITPart # 6837701 Revision: 07/06/991ASSEMBLY INSTRUCTION
1001234561/2 1/2 1/2 1/2 1/2 1/2 FIGURE 12STEP 12• Attach one 3-1/2” PULLEY (4) to the FRONT LEG (1) and one 3-1/2” PULLEY (4) to the BASE CONN
FIGURE 14STEP 14• The 832 LEG PRESS is equipped with a spring pin adjustment to accommodate different sized users and allow easy entry and exit
There is a risk assumed by individuals who use this type of equipment. To minimize risk, pleasefollow these rules:IMPORTANT NOTES1. Consult your physi
FIGURE 1STEP 1• Slide two 2” SQ. COVER CAPS (6) over the FRONT LEG(1) as shown in FIGURE 1. 1 6PARTS LIST3PART #6838003669390268381033116201640
FIGURE 4STEP 4• Remove two 1/2 X 4” BOLTS, two 1/2” WASHERS, and two 1/2” LOCK NUTS from the BASE and STACK GUARD as shown inFIGURE 4. (NOTE:
5STEP 6Remove the existing CABLE (part #68331) using the following steps:• Unscrew the threaded end of CABLE from the HEAD PLATE ASSEMBLY.• Route t
6STEP 7Install the NEW PRIMARY CABLE (13) using the following steps:• Route the CABLE (13) back over one pulley in the GUIDE ROD SUPPORT, down thr
FIGURE 87STEP 8• Loop CABLE (13) around one 3-1/2” PULLEY (4) in the PULLEY BRACKET (2) and SECURELY assemble using one 3/8 X 2”BOLT (10), an
8 FIGURE 10STEP 10• Assemble the LEG PRESS CABLE (14) to the ADJUSTMENT TUBE on the 832 using the existing previously removed 3/8 X 4-1/2”BOLTS,
FIGURE 11STEP 11• Securely fasten the 832 LEG PRESS to the FRONT LEG (1) using two 1/2 X 3” BOLTS (11), two 1/2” WASHERS (15), and two 1/2” L
Comentários a estes Manuais